The first tab in Balthzar ERP Connector is called "Information", and it is used for general information, as well as specific customer/company data.
Status
Status will be
updated on a regular basis with text describing what is happening in the
program. If there is any problems there will either be an error message here or
an error message saved separately as a log file.
Last error
Should be empty
but if something else then what is shown in the picture above is visible here
that is an indication that something is wrong.
Memory used
Here you will
see a number which will indcate the average number of bytes the program uses.
This is used by Delacroy when searching for errors.
Column 2
Company ID
Here you
will see the ID of the company.
Company key
Here you will see the password for the company.
Transfer delay run time(min)
Enter the
amount of minutes it is suppoed to take before a transfer is done regarding run
time.
Transfer delay stop time
(min)
Enter the amount of minutes it is supposed to take before a transfer is
done regarding stop time.
Enable
logging
Use "Yes" to start an extended log which will describe how
the program handles transactions queued up for processing.
ERP
System
Here you will see what ERP system is used and that will in
turn control how the program handles transactions.
Scheduled
transfer interval (min)
The amount of time (min) used when one
transfer is finished and another transfer is started.
Notify errors
email
If something should go wrong during the transfer
an error message will be sent to this email adress.
Transfer manual quantity interval
(s)
Enter the amount of time, in seconds, it
should take before a manual transfer is done.